Monday,15-December-2014
Xantia II - rear wiper
BG: на български
EN: My rear wiper was just stuck. Any attempt for use lead to burn fuse. So here is what i decide to make:
Remove the mottor, and remove all rivets that keep the aluminum cover. That will be replaced by small screws. Just drill suitable holes for M3.5 or M4.0
Clean really well the mechanical part and check the bronze contacts. Add grease.
After that open the relay cover with screw drivers and check for broken soldier points same as marked on the image. Clear the contacts, what is possible by gently pull out the contact plate.
Here how you can save few bucks by not paying for new unit.Good luck!
Add comment
Fill out the form below to add your own comments