Saturday,28-April-2018
Sinumerik 840D Easy - Spiral out-in
EN
Have you get some times to the point, that you like to create nice finish top surface of some cylinder object?
Me to too, so I decide to share code how you can do that in Sinumerik 840D.
Here is the code:
There is only few things I with to point, to be sure you get same result:
- the automatic getting tool`s offset radius work only with the tool in spindle. If you do the simulation and change for example from endmill 60mm to 32mm, but in spindle still is 60mm loaded, the your graphic will come totally different
- perhaps you see some places R2*1.2 - that 1.2 is times the radius. If you go raw with same cycle perhaps you can use only R2 (tool radius as step). For finishing it goes 1.2-1.8 times the radius of the tool
Hope, it will be in some help to you ;)
