Saturday,19-November-2022

Mitsubishi M700 and Servo Mitsubishi MDS-D alarm fix

EN
That is topic dedicated to alarms and trouble codes in Mitsubishi M700 control , caused by defective servo module MDS-D and low backup memory battery.
Most of that MDS-D servo units have own backup battery to keep some settings “alive”. But in my case there was common block as that one:

servo_4.jpg

Getting old and bad, the battery cause constant lose of absolute axis points. So, how that can be that issue fixed ans so on please read below :)

First here is the list of the error codes:

Z70 Abs posn error
S52 Battery voltage drop
Z73 Battery for abs data fault
and so on..

servo_1.jpg
servo_2.jpg

All axis modules in my case was connected to common battery pack:

servo_3.jpg

By the cables, I found the block at the right end of the cabinet. And it look like that:

servo_4.jpg

Then, battery been replaced:

servo_5.jpg

That remove the S52 and Z73 alarms, but still left the Z70 ones. With that matter , we will deal just in a minute.
Most important was to get rid of the servo issues. And that is because it just simply will not start:

servo_7.jpg

As it seems, that is quite common thing among the old MDS-D modules and is caused by small 33uF capacitor.
Now, need to be taken the whole servo unit out:

servo_8.jpg

open it…

servo_9.jpg
servo_10.jpg

and here is the “bad boy”:

servo_11_1.jpg

sometimes also the IC can be problem:

servo_11_2.jpg

So here is the replacement: 33uF @ 50V

servo_12.jpg

Here is the place to mention that is multilayer PCB and you need to remove it absolute carefully!!!

Once job done, you`ll see hopefully something like that:

servo_13.jpg

And I was left finally with that ones:

servo_14.jpg

For them to be solved, you need to get full access to the parameters, so on the password request write : MPARA
When there, go to ABS-set

servo_15_1.jpg

set the marked position to 1 and you`ll get the “state” condition ready. Please remember, that you need to do that for any axis what relay to battery backup!
Then, after restart of the NC-Control, you`ll get hopefully to that point:

servo_16.jpg

Hope that small write up was in any use to you!
After you get

  mail

Tags

  Graphic     Една история..     Cars     Финландия..     WEB     Амстердам..     Audio     Shoes     Home     Tech     CNC     Design     Citroen  

Calendar

  • April 2023
    SunMonTueWedThuFriSat
     1
    2345678
    9101112131415
    16171819202122
    23242526272829
    30 

Admin area

Adds

3dultimatedesign.jpg