Saturday,22-April-2017

Woodpecker GRBL CNC Board - Firmware Update

  • Posted by longgo at 20:52:12 in CNC

    • EN
    If you own CNC 2418 machine(like me), or just have Woodpecker GRBL CNC Board you can update to GRBL firmware v1.1.
    But if you`re “lucky” like me,when try via Arduino IDE, you`ll hit into: “resp. = 0×0d” or similar compiler error. That is because the Atmel chip is without boot loader. Even with Xloader you`ll hit the wall. So then what?
    [Read More…]

    Friday,14-April-2017

    Jetta 1K2 - immo problem [solved]

  • Posted by longgo at 09:55:22 in Cars

    • EN
    Have to admit - sometimes VW make really good puzzles for solving with their documents. This time the car that will talk about is Jetta model 2006. 1.6 FSI with average equipment.
    The problem was that after visit to service the car suddenly lost central lock. Dealer conclusion was: you need new set of keys and front doors lock motors replaced. Well…
    [Read More…]

    Lenovo K910 power cable fix

  • Posted by longgo at 09:23:18 in Tech

    • EN
    Lenovo K910 - not that bad phone, but the owner of that Chinese marvel grumble that in few days it did charge only from time to time, and when move the power supply cable sometimes it work sometimes not.
    From ebay was ordered new ribbon cable and here how it goes..
    [Read More…]